http://https://www.newpassleader.com/Juniper/JN0-347-exam-preparation-materials.html (65 Q&As Dumps, 30%OFF Special Discount: 30free )

NEW QUESTION NO: 30
Which two statements are true about Virtual Chassis? (Choose two.)
A. The member ID is not preserved through reboots.
B. Virtual Chassis members use VCCP to create a loop-free topology.
C. It is possible to automatically update the Junos OS on newly added members to participate in the Virtual Chassis
D. A software version mismatch on a newly added member must be placed in linecard mode.
Answer: B,C

NEW QUESTION NO: 31
There is a GRE tunnel configured over the Internet between Router-1 and Router-2. An OSPF adjacency is configured over this GRE tunnel. However, the OSPF adjacency briefly reaches the Full state before it is torn down. This cycle repeats indefinitely.
Which two actions would you perform to solve this problem? (Choose two.)
A. Configure OSPF to not export the tunnel endpoint interface routes.
B. Configure static routes to the tunnel endpoints.
C. Configure the GRE interfaces on both routers as passive interfaces in OSPF.
D. Configure the physical WAN interfaces on both routers as passive OSPF interfaces.
Answer: A,B

NEW QUESTION NO: 32
What is considered a requirement for passing traffic through GRE tunnels?
A. You must be able to reach the remote endpoint through the tunnel.
B. Tunnel endpoints must have a route that directs traffic into the tunnel.
C. You must configure the tunnel on the physical interface connecting to the remote endpoint.
D. Tunnel endpoints must have static routes pointing to the remote endpoints.
Answer: A

NEW QUESTION NO: 33
A customer discovered that a significant outage was caused by an unauthorized Ethernet switching device attached to the network.
In this scenario, which two actions would solve this problem? (Choose two.)
A. Enable storm control.
B. Enable dynamic ARP inspection.
C. Enable 802.1x.
D. Enable persistent MAC learning.
Answer: C,D

NEW QUESTION NO: 34
Which three mechanisms are associated with the bridging process? (Choose three.)
A. pruning
B. learning
C. filtering
D. flooding
E. listening
Answer: B,C,D

NEW QUESTION NO: 35
You disconnected a switch from the Virtual Chassis, but the disconnected switch's member ID is still displayed in the status output.
Which operational command is used to remove the disconnected member?
A. request virtual-chassis renumber member-id 3 new-member-id 2
B. request virtual-chassis recycle
C. request virtual-chassis reactivate
D. request virtual-chassis vc-port delete pic-slot 2 port 0
Answer: B

NEW QUESTION NO: 36
Which two statements are true about nonstop bridging (NSB)? (Choose two.)
A. NSB requires you to configure graceful Routing Engine switchover (GRES).
B. NSB does not require all participating Routing Engines to run the same version of the Junos OS.
C. NSB can be enabled under the protocols layer2-controlhierarchy.
D. NSB does not require you to configure graceful Routing Engine switchover (GRES).
Answer: A,C

NEW QUESTION NO: 37
Click the Exhibit button.

You are troubleshooting an IS-IS adjacency problem as shown in the exhibit.
Which action would solve the problem?
A. Configure matching authentication keys.
B. Configure the ISO family for the loopback interface.
C. Configure the INET6 family for the loopback interface.
D. Configure matching area IDs.
Answer: D

NEW QUESTION NO: 38
Click the Exhibit button.

You are monitoring your IS-IS router and issue the command shown in the exhibit.
Which two statements are true in this scenario? (Choose two.)
A. The name of the remote device is r1.
B. The name of the local device is r1.
C. The loopback address of the local router is 5.0.0.100.
D. The loopback address of the local router is 10.100.0.1.
Answer: A,D

NEW QUESTION NO: 39
Which two statements are true about the IRB interface? (Choose two.)
A. An IRB interface cannot be associated with any VLAN.
B. An IRB interface is a Layer 3 VLAN interface.
C. An IRB interface is used to route traffic between VLANs.
D. An IRB interface is a Layer 2 VLAN interface.
Answer: B,C

NEW QUESTION NO: 40
Click the Exhibit button.

The configuration shown in the exhibit was committed on an EX Series switch. You are notified that the phone using the voice VLAN does not work. You determine that voice traffic is not passing through the local switch.
What should be done to solve the problem?
A. You should change the voice VLAN ID to match the data VLAN ID.
B. You should add the voice VLAN as a member on the ge-0/0/8.0 interface.
C. You should change the port mode on ge-0/0/9.0 to trunk.
D. You should add the voice VLAN as a member on the ge-0/0/9.0 interface.
Answer: B